Spacers

Will spacers hurt your utv if installed ?

Some say they will increase bearing wear but I don't know about that. I have a set installed on a Rzr . Changed front bearing at 1400 miles and now the backs need changed at 2000 miles. I have friends who have a lot less miles on their rzrs and they have had to change bearings long before I did.

The simple answer is, No.

My opinion on my Grizzly is that roll overs hurt more than bearing replacements, running 5" wider than stock on the ATV.

i have heard both ways good and bad

Going with highlifter spacers ,anyone know of them and are they a good brand?

billybob wrote:

Will spacers hurt your utv if installed ?

What are you wanting to install spacers on? RZR S or standard RZR?

It,s a 50inch rzr le.

Are you talking about wheel spacers or shock spacers?

The 26x12x12x bighorn tires rub on the right side motor mount so I need to move them out a little to fit.

So wheel spacers then, just make sure you get a quality billet spacer and you'll be ok.

i agree with rzr joe make sure u buy good billet spacers. no cheap stuff

I got Highlifter spacers coming have you heard of them?Was told it was a good brand.

billybob wrote:

I got Highlifter spacers coming have you heard of them?Was told it was a good brand.

Yes they are. You should be good to go.

billybob wrote:

The 26x12x12x bighorn tires rub on the right side motor mount so I need to move them out a little to fit.

Spacers will fix the rear from rubbing on the motor mount but they may cause your front tires to rub more --it changes the turning radius of the front tires with in the fender well and will rub. You will also notice that your steering will suffer somewhat...

Put my spacers on today and mounted my new tires like the look ,no spacers on the front.