Rhino color change

This was green when my friend Stan bought it a few weeks ago!

i like the camo on the doors and panels might have to steal that idea i know for my yamaha on the tailgate im gettin this made soon

I painted my tailgate blue

Did you use some special paint? What about primer? How is it holding up?

That camo is sharp. I think the camo looks awesome cleaned up.

that camo looks real clean, i like especially the rear tail gate.

what rhino - cant see it

does look like a real good job!

I also like the YAMAHA in color - consider it thefted again!

KRYLON FUSHION BABY!!!!!! YOU CAN PAINT ANY KIND OF PLASTIC AND IT WILL HOLD

Wheelin wrote:

KRYLON FUSHION BABY!!!!!! YOU CAN PAINT ANY KIND OF PLASTIC AND IT WILL HOLD

that's right krylon fusion be sure to get it clean first ,and rough it up a bit. i use lacquer thinner to clean with don't know how it will hold up just done it Saturday

ive had mine painted sense the late summer..its holding great just like my paint

Yeah i wonder how it will hold up when you hit it with a pressure washer?? I wouldn't hold it on it, but it spray over it i'd think it would chip.

I promise you if you do your prep work the krylon will hold.. i pressure wash mine all the time

Sweet i'll give it a shot this weekend. It's going to be a pain taping up!!

what are you painting

Letters on the tail gate.

cool..use some scotchbrite pade and rough it up first..put light coats on to

joshc wrote:

Sweet i'll give it a shot this weekend. It's going to be a pain taping up!!

I have been wanting to do mine for a long time. I was going crazy not being able to do much with the bum foot so I got me two buckets, one to sit on and one to prop my foot on and went to work. Took me about an hour or so to mask it off. The best way I found to tape it was to let the tap lay up on the letters a little then take a straight edge and razor knife and cut the edges, it will give you a nice straight line, then just round the corners of the letters. The center letters were the hardest, lay some wide masking take over the center and take your finger and press it down good and it will show you the inside edge, then just cut it there and press it down into the letter may have to do some fine tuning on the tape. After you put four or five coats of paint on it let it set for five or ten min. then pull the tape off VERY SLOW if you let it set to long it will flake the edges off . Hope this helps.

Sweet, thanks alot for the tips.

That looks like a camo clad correct? How difficult was it to put on? I have been thinking about ordering a very similar pattern myself.

CamoClad it is! The picture is my buddy's ride after they go it done. It took them around 6 or 7 hours to put it on, but they were very particular in doing it. If you will look they painted the area around the tail lights, line down the top of the bed,inside of the grill and the hood indentions with black camo paint.

FLY TRAP wrote:

CamoClad it is! The picture is my buddy's ride after they go it done. It took them around 6 or 7 hours to put it on, but they were very particular in doing it. If you will look they painted the area around the tail lights, line down the top of the bed,inside of the grill and the hood indentions with black camo paint.

it came out really really good, I have heard that it is very difficult to install??

r6realtor wrote:

FLY TRAP wrote:

CamoClad it is! The picture is my buddy's ride after they go it done. It took them around 6 or 7 hours to put it on, but they were very particular in doing it. If you will look they painted the area around the tail lights, line down the top of the bed,inside of the grill and the hood indentions with black camo paint.

it came out really really good, I have heard that it is very difficult to install??

y u shoulda got the camo to begin with

shawnley1222 wrote:

r6realtor wrote:

FLY TRAP wrote:

CamoClad it is! The picture is my buddy's ride after they go it done. It took them around 6 or 7 hours to put it on, but they were very particular in doing it. If you will look they painted the area around the tail lights, line down the top of the bed,inside of the grill and the hood indentions with black camo paint.

it came out really really good, I have heard that it is very difficult to install??

y u shoulda got the camo to begin with

I wish I would have but when I bought mine there wasn't any to be found! YOu all ready for the mud this weekend?

[/quote]

I wish I would have but when I bought mine there wasn't any to be found! YOu all ready for the mud this weekend?[/quote]


you know it waitin on my new skid to dry puttin it on loadin it up on the trailer then headin to work :D ...its too bad you aint gonna make it :|

shawnley1222 wrote:

I wish I would have but when I bought mine there wasn't any to be found! YOu all ready for the mud this weekend?[/quote]


you know it waitin on my new skid to dry puttin it on loadin it up on the trailer then headin to work :D ...its too bad you aint gonna make it :|[/quote]

You know it really stinks to because I have a meeting at 8:00 in the morning on sat. and usually don't even have to be at work until 10:00 My whole weekend is just shot!