EMP boot guards and the rear brake lines

I know several have the EMP boot guards. What did you guys use to protect those rear brake lines? If you have a picture of your setup, it would be appreciated. I was thinkng some small rubber line with zip ties, then possibly coating it all with some liquid tape.

I didn't have to do anything to mine...

What problem exists?

mine were fine, you can move them around a little if they are close to something.

Cool. I will try that Gunny. Thanks.

if they are rubbing, buy some clear hose at the hardware and slit it and slip it over and add a few zip ties to hold it in place.

I used a piece of old gas line with zip ties.

I installed mine last week and noticed that too. My brake lines do not have enough play, unless I remount them. The edge looks like it will wear it fast. I'll try some silicone tubing I have and sleave it.

Springs look good Gunny!!!!!!!!!!!

ridepate wrote:

Springs look good Gunny!!!!!!!!!!!

Ditto

thanks,those are the makintrax springs, hope to test them soon