utvinc rock sliders on a 2010 teryx

can any one help me how to install utvinc rock sliders on my ride. nothing is lining up. the fronts bolts look like they will bolt up but the rears says remove the screws holding on the inner fender well and it lookd like you just drill them out but the holes dont line up. then the outer bolt on the back where you have to drill through does not go through the square frame but is blocked by the bottom part of the slider from being able to put a bolt and nut on. can any one help me put these things on????????

I would contact UTV Inc. I know the Teryx has changed frames about 4 times from 2008-2010. Hope that has nothing to do with your problem. I would ask UTV Inc what Teryx they designed them to fit on.

they were no help

Mudcon wrote:

they were no help

That is why I made my one and only purchase from them last year.

PWM wrote:

Mudcon wrote:

they were no help

That is why I made my one and only purchase from them last year.

Same here....Never again.

Snap some pics Mud, maybe we can help ya.

ridepate wrote:

PWM wrote:

Mudcon wrote:

they were no help

That is why I made my one and only purchase from them last year.

Same here....Never again.

Snap some pics Mud, maybe we can help ya.

I have never bought anything from them. I almost bought their doors for the RZR but did not. It is a nice door but.......... Well I will leave it at that.

I agree with pate Mud. If you can post some pics we all might be able to give you some ideas.

its will be the last time I do, I have been dealing with it since december or them since december. never again...... over the weekend I finally got something to work. I went and got 1 inch bolts and just welded a nut on the back side of that 2 inch but 2 inch opening that gets covered up with the bottom of the rock sliders when they are on so you cant get a wrench in there for chit. even the front had a quarter inch gap that did pull in when I tighten it down but the instructions say it should be a TIGHT fit...... yea right. anyways lesson learned.

Gald ya got them on Mud.

took alot of beers and alot of cussing

Mud, I have the DG sliders/nerf bars and I never could get instructions for them either. My local dealer got them on for me (Gateway Cycles).
Mine have detinitely saved my side plastic several times,Good luck with yours.