Tilt Steering

I could see where this would be awesome. Especially for those of us with Harnesses.


http://www.proprecision.com/index_files/Page392.htm

I think my steering wheel is in a good position.
but i am almost certain after Kentucky.
i am going to put the power steering system on it.
the unisteer......

My steering wheel felt good when I could "Git up on it." Now with the Harness on it is not feeling real good to me where it is at.

Hey Yank, I've got your mod, it's free and will lower the wheel about an inch plus. You can loosen the mounting-plate, behind the dash, 4-bolts, also loosen the steering-shaft U-joint there. Remove the two bottom bolts and shim the plate on the forward end, I used a spacer on each side. When you loosen the plate you will see what i mean, the wheel will drop. There is enough play in the groove on the shaft at the U-joint to let the wheel go down.

Ya Pate , but ant your colum off center in the dash hole now?
You know how anal i am.......

wvyankee2 wrote:

My steering wheel felt good when I could "Git up on it." Now with the Harness on it is not feeling real good to me where it is at.

Marty , I had the same problem in my outlaw camaro. remember the sholder straps are to hold
you in place. but thay dont haft to have you pined in the seat.
its not like you are going 200 MPH. just loosen them up where you can move a bit.
Trust me , if you roll it . you ant going no where.

Chris.....

ChrisC wrote:

Ya Pate , but ant your colum off center in the dash hole now?
You know how anal i am.......

Chris, No now it is in the center. Most 660's I've seen the colum comes out-d-hole at the top. Not sure why....... But now I'm centered and anally correct!!!!!!

I will haft to look at mine close and see how it is now....

I just don't know about this place no more.
All I hear from this bunch lately is,
Anal, Mount and Screw.

Yankee, gonna have to hire you just to find me the good stuff!

DirtDawber wrote:

I just don't know about this place no more.
All I hear from this bunch lately is,
Anal, Mount and Screw.

Don't forget whole....

And coming.

Last night in the chat, Yank said, "I'm ready to ride boys." I'm still laughing on that one.

Id hit it!

DirtDawber wrote:

And coming.

Last night in the chat, Yank said, "I'm ready to ride boys." I'm still laughing on that one.

I didn't know yank wanted to be a priest.